Length 23.9cm x Width 4.7cm x Height 14.3cm
a- Length 23.9cm x Width 4.7cm x Height 8.2cm
b- Length 14.4cm x Width 2.3cm x Height 1.0cm
c- Length 19.0cm x Width 2.8cm x Height 0.3cm
A side bead molding plane comprised of three parts, a rectangular wooden body with an angled cutout through the middle and a side bead profile on the sole (a), a wooden wedge that tapers to a point at the bottom and is rounded at the top (b), and an iron with a curved blade to match the profile of the plane (c). The wedge and the iron fit together inside of the angled cutout, and the wedge holds the iron in place as the plane runs across the wood surface below. Stamped on the toe of the plane is "WALLACE" and "I BLOWER". Stamped on the heel is "I BLOWER" and "7/8". Stamped on the iron is "W. BUTCHER".
Side beads, or beading planes, are used to put a bead along the edge of a board, and can be used in many situations, such as back boards, the bottom of table aprons, or along shelf fronts. A very versatile plane, these were, along with hollow and rounds, perhaps the most common molding plane produced. These are one of the easiest molding planes to use, with an integral fence and depth stop, and no spring. (The plane is held vertically.) Simply hold the plane against the edge of the stock being profiled, and make passes until the depth stop prevents any further cutting. For a different treatment, running the plane along two sides of a corner will produce a 3/4 bead on that corner.
